IBM Books

Addendum to Nways Manager for Windows NT Installation Guide

Installing DB2

Reference to Checklist:This section corresponds to step 9.
Note

If you have verified that you already have DB2 and FixPak 8 installed on your system, or will not be using DB2 as your database for Nways Manager Version 2.0, then continue with "Installing License Use Runtime".

Otherwise, follow these instructions for installation:

  1. Insert the DB2 CD. Allow the install to start if autorun is enabled. If autorun is disabled, click Start -> Run and type e:\setup.exe, where e is the CD drive.

  2. Click Next.

  3. Select the type of install. Typical is recommended.

  4. Choose one of these three options:

  5. Click Next.

  6. Type in the Administrator's username that was created at the beginning of the process, or the Network Management username that you are currently using.

  7. Type in the password for that username.

  8. Type in the same password again to confirm.

  9. Click Next.

  10. Click Install to start copying the files.

  11. After the files finish copying (approx. 4 minutes), remove the CD from the drive.

  12. Click Finish to restart Windows NT.

[ Top of Page | Previous Page | Next Page | Table of Contents ]